Coda C3 Betriebsanweisung PDF herunterladen (Seite 18)

Factory settings determined entirely by the Factory preset file from Coda Audio

(called “Factory voice”) – see Loading Factory Presets, or

Your own settings (called “User voice”) which overlay these basic factory settings.

A recessed Defeat button on the front of the amplifier allows you to select between

Factory and User DSP settings. Click the button to toggle between these two modes.

When the User DSP indicator is off, the amplifier is in Factory voice. In the Factory voice,

you cannot change any of the settings; they are fixed by Coda Audio (and thus are a safe

„fallback‟ if something goes wrong with your settings). Only when the indicator is on will

changes you make in C-Net be heard. Note however that if you make adjustments on the

C-Net control panel when the amplifier is set to Factory voice, the settings are changed

and stored in the amplifier, but you will not be able to hear the changes until the button is

set to User DSP. A red warning message will be shown on the C-Net panel when in

Factory voice.

An indicator at the top of the C-Net panel to the right of the status indicators also shows

the Voice setting of the amplifier (Voice 1 – User, or Voice 2 - Factory).

If you wish to make the amplifier entirely secure from tampering, you can disable the User

DSP button by ticking the “Disable User Defeat Button” tickbox on the Properties / Options

tab of the C-Net control panel. This locks the amplifier into the User Voice regardless of

the setting of the push button.

Also see Loading Factory Presets and Aux In Port

Main Control Panel

The Input area allows you to adjust the input sensitivity of each input of the amplifier, and

to change the polarity of each input, allowing you to reverse the phase of the

loudspeakers fed from that input.

The Output section allows you to control the output drive level of each amplifier. Also,

depending on which parameters have been hidden by Coda Audio, you may also be able

to:

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 30 31

Keine Kommentare

Coda C3 Betriebsanweisung Seite 18